Your position: HOME > NEWS > INDUSTRY NEWS >


  • Line Stopping2014-02-25
    Line Stops, sometimes called Stoppling or line pluggingstart with a hot tap, but are intended to stop the flow in the pipe. Line Stops are of necessity, somewhat more complicated than normal ... Read more >
  • Line Stop setup2014-02-25
    The Line Stop Setup includes: 1. Cylinder stopple method: the hot tap machine,cylinder plugging machine, hydraulic power uint,completion machine,wafervalve, four-way tee(stopple fitting), exp... Read more >
  • What is a Hot Tap and why it is made?2014-02-24
    Hot Taps or Hot Tapping is the ability to safely tie into a pressurized system, by drilling or cutting, while it is on stream and under pressure. Typical connections consist: Tapping fittings... Read more >
  • Remarks before made a Hot Tap2014-02-24
    A hot tap shall not be considered a routine procedure, but shall be used only when there is no practical alternative. Hot Taps shall be installed by trained and experienced crews. It should b... Read more >
  • Hot Tap operation2014-02-24
    The Hot Tap is made in one continuous process, the machine is started, and the cut continues, until the cutter passes through the pipe wall, resulting in the removal of a section of pipe, kno... Read more >
  • 15条记录


Pipeline reroute project at Xi Hua village, Nanan City

Contact Us

Contact: Jessica Huang
Tel:0086-790-6860686 / 18870285586
Address: No.111, Tantang Road, the New Advanced Technology Development Dist, Xinyu City, Jiangxi Province, China 338004
Member Service